Feature:1. The oscilloscope has a built-in high-voltage protection module that can withstand continuous voltages up to 400V.2. There are three trigger modes: automatic/normal/single, it is easy to catch instantaneous waveforms.3. Fully fit a 7inch 800 x 480 resolution color TFT LCD display, with bright colors and high contrast.4. The touch method is a capacitive touch screen, which is the same as the touch method of modern mobile phone pad.5. Widely used in academic experiments, electronic product design, debugging and maintenance, electronic engineering education, etc.Specification:Iteam Type: OscilloscopeModel: 1013DMaterial: PlasticApplication: Electronic production, home appliance repair, gas car repair, equipment debugging, scientific research and education, product developmentThe Highest Test Voltage: 1x40V 10x400VPlug Specifications: US plugVoltage: 110-240VCursor Type: Horizontal X, horizontal Y, trigger YRolling Mode: SupportNumber of Channels: 2Screen Size: 7 inchesScreen resolution: 800 x 480Display Process: TFTWaveform Storage: 1000 screenshots + 1000 groups of waveformsAnalog Bandwidth: 100MHzMaximum Sampling Rate: 1GS/sVoltage Accuracy: 2%Rise Time: <3nsFrequency Accuracy: 0.01% high accuracyStorage Depth: 240KbitMeasurement Parameters: 12 kinds in totalInput Impedance: 1MVertical Sensitivity: 50mV-500VStandby Time: 4 hoursTime Base Range: 50S-10nsExpansion Interface: USB transmission interfaceTrigger Mode: Single/normal/autoTrigger Edge: Rising edge/falling edgeCoupling Mode: AC/DCCharging Requirements: Typec 5V 2A/3A/4ABattery Parameters: (Battery Included)Battery Attributes: Lithium batteryBattery Capacity: 6000mah.Package List:1 x Oscilloscope (Battery Included)1 x Manual 2 x Probe2 x Protective Caps8 x Color Circle1 x Pressure Regulating LeverNote:1. Strictly limit the amplitude of the input signal. When a large signal is connected to the oscilloscope, it is necessary to estimate the signal level first, and select a suitable attenuator to attenuate the signal to prevent the large signal from burning the input channel of the oscilloscope2. When the oscilloscope probe is connected, it should be applied slowly and evenly to avoid damaging the connection port3. Regular inspection and maintenance. The oscilloscope is heated for half an hour at least once a month. Do SPC operations on the oscilloscope4. Pay attention to the use environment and avoid using the equipment in an environment with excessive dust; use it sparingly and don't drop it5. Pay attention to the electrostatic protection of the instrument channel interface;6. Avoid hot plugging of interfaces and cables7. When using the probe, pay attention to avoid pulling, pulling and bending, avoiding impact/dropping, etc.