Three-blade component — Right-hand rotation (R) Key benefits Stable, balanced operation: A 3-blade design helps distribute load evenly for smoother rotation and reduced vibration compared with uneven blade counts. Correct rotation match: Marked R for right-hand (clockwise) rotation; fits systems that require a right-rotating part and prevents reverse-torque issues. Simple replacement: Directly replaces worn or damaged 3-blade, right-rotation parts when match on blade count and rotation direction is required. What this part does Number of blades: 3 — provides the intended aerodynamic/mechanical profile for the original application. Rotation: R — designed for right-hand (clockwise) rotation when viewed from the drive end; critical for correct thrust and safe operation. Compatibility and fit guidance Confirm compatibility before purchase: verify shaft size, mounting hole pattern, overall diameter, and any hub or locking requirements with your equipment. Intended for use wherever a 3-blade, right-rotating component is specified. Do not install in systems that require left-hand rotation. Performance and durability notes Performance depends on the original equipment design and installation. Proper fit and secure mounting are required to achieve expected balance and service life. Inspect mating surfaces and fasteners during replacement to avoid misalignment or premature wear. Typical use scenarios Replacing a worn 3-blade, right-rotation fan or propeller in small electrical or mechanical assemblies (confirm dimensions before ordering). Swapping out a damaged cutting or trimming blade assembly that specifies three blades and right-hand rotation. Restoring a hobbyist or DIY propeller assembly where the original design calls for a 3-blade, clockwise-rotating part. Installation reminders Verify rotation direction (R = right/clockwise) and blade count match the original part. Check shaft diameter, keyway, and fastening method; tighten to the manufacturer’s torque specifications. If uncertain about fit, consult the equipment manual or supplier with measurements before installation.