Manual High Pressure Air Pump Portable Inflator with Pressure Gauge for Oxygen Cylinder Diving

159,00 €
doručenie ZADARMO

Manual High Pressure Air Pump Portable Inflator with Pressure Gauge for Oxygen Cylinder Diving

  • Značka: Unbranded
Predáva:

Manual High Pressure Air Pump Portable Inflator with Pressure Gauge for Oxygen Cylinder Diving

  • Značka: Unbranded
Odporúčaná cena: 199,00 €
Cena: 159,00 €
Ušetrili ste: 40,00 € (20%)
Predáva:
159,00 €
doručenie ZADARMO

Na sklade

Akceptujeme nasledovné platobné metódy

Popis

Features:Made of high quality stainless steel, anti-rust and durable. High pressure air pump by hand, 53cm/20.9in length air pump tube. Simple to operate, making diving become easy, no need to carry large scuba.With a pressure gauge on it, you can know when to stop inflating. Portable and practical, essential accessory for diving. Specification:Material: Stainless SteelColor: Shown as picturesAir Tube Length: Approx. 53cm / 20.9inConnector Diameter: 3.1cm / 1.2inConnector Length: 9cm / 3.5inWeight: Approx. 2840gPackage List:1 * High Pressure Air Pump (with Connector and Air Tube)1 * Wrench(Size: 14.8 * 5 * 0.25cm / 5.8 * 2.0 * 0.1in)2 * Packages of Accessories1 * ManualNote:1. High-pressure air pump, in the process of air inflating due to up and down friction, resulting in fever, this phenomenon is normal.2. The phenomenon of oxygen cylinder respirator can't be inflated: firstly, when oxygen cylinder respirator is delivered, it does not contain gas, secondly, check the high-pressure pump before inflating the high-pressure pump, assemble it according to the instructions, install the gasket rubber ring, tighten the exhaust valve, and then inflate it. This product is different from oxygen pumps such as basketball, volleyball. Effectively, please be patient to inflating for two or three minutes before the pressure gauge will change. It takes three men to inflating about 16 minutes for each oxygen cylinder to fill up. Within 3000PSI, it is within the normal range. Over 3000PSI may burst (please don't inflating too full).3. Oxygen cylinder head and body should be checked for tightness, good connection and not standing above the oxygen cylinder when inflating. Be careful not to inflate the oxygen cylinder to a certain pressure. Oxygen has certain impact. Please pay attention to safety.4. When the pumpis finished, please notice that it is dangerous to twist the exhaust valve of the high-pressure pump and suddenly pull out the connecting port between the pump and the oxygen cylinder.5. Please note that the new type and old type of this product will be sent randomly, and make sure you will not mind before ordering..
  • Fruugo ID: 416656014-879131033
  • EAN: 7540131903014

Informácie o bezpečnosti produktu

Prečítajte si informácie o bezpečnosti produktu špecifické pre tento produkt uvedené nižšie

Nasledujúce informácie poskytuje nezávislý maloobchodný predajca tretej strany, ktorý predáva tento produkt.

Bezpečnostné štítky produktu

CE Mark
Bezpečnostné upozornenia: Warning: Please read the product instructions carefully before use to ensure correct use.
Sériové číslo: 7540131903014

Dodanie a vrátenie

Odoslané do 2 dní

  • STANDARD: Zadarmo - Doručenie medzi st 22 októbra 2025–st 29 októbra 2025 - Zadarmo

Doručenie od Čína.

Snažíme sa, aby sme výrobky, ktoré si objednáte, doručili celkom v súlade s vašou špecifikáciou. Ak by ste však dostali neúplnú objednávku alebo iný tovar ako ten, ktorý ste si objednali, alebo existuje nejaký iný dôvod, prečo nie ste s objednávkou spokojní, môžete objednávku alebo niektoré produkty z nej vrátiť a za tovar dostať plnú náhradu. Pozrite si všetky pravidlá vrátenia

Podrobnosti o zhode produktu

Pozrite si informácie o súlade špecifické pre tento produkt uvedené nižšie.

Nasledujúce informácie poskytuje nezávislý maloobchodný predajca tretej strany, ktorý predáva tento produkt.

Výrobca:
Nižšie sa nachádzajú kontaktné informácie výrobcu príslušného produktu, ktorý sa predáva na Fruugo.

  • Wuhan Pinsheng Technology Co., Ltd.
  • Wuhan Pinsheng Technology Co., Ltd.
  • No.A357,Shoulder-to-shoulder?Incubator,Building?4
  • Wuchang District
  • Wuhan
  • CN
  • 430000
  • pinsenkj@163.com
  • 18062524796
  • https://shop01473o1711614.1688.com/page/creditdetail.htm?spm=a261y.7663282.shopNavigation.1.6310755czE9SFQ

Zodpovedná osoba v EÚ:
Nižšie sa nachádzajú kontaktné informácie zodpovednej osoby v EÚ. Zodpovedná osoba je určený hospodársky subjekt so sídlom v EÚ, zodpovedný za dodržiavanie povinností súvisiacich s príslušným produktom, ktorý sa predáva na území Európskej únie.

  • None
  • Kequ Technology s.r.o.
  • Pražákova 1008/69
  • Štýřice
  • Jihomoravský kraj
  • Brno
  • CZ
  • 63900
  • christopher25106@outlook.com
  • 420608214795