Top 2 Reasons To Get EWS2 EWS3.2 EmulatorThere are NO any counters or car starts limited. You can change and store new ISN without any limitations.Emulator is shipped with JUMPER 1 shorted. For testing purposes ISN 0579 is stored by default.Notice: In case of EWS3.2 similar procedure is used, only difference is that that it is NOT connected directly to diagnostic K-line.Installation:1. Remove EWS2 control unit, find +12v ACC, GND, K-line wires, attach emulator. Emulator must be in service mode: JUMPER 1 shorted.2. Connect ANY K-line diagnostic adapter to vehicle diagnostic connector and launch EMULATOR CONFIGURATION UTILITY:3. Choose COM port, write in desired ISN number, press button Store. Or -4. For some ECU s it is possible to read ISN number directly from engine control unit. In this case select option ECU xxxxx , press Read. Software will try to read ISN. If successful, choose option EWS emulator and press button Store to save ISN number into emulator.5. Disconnect emulator from K-line, remove JUMPER 1 and connect K output from emulator to DME(DDE) -EWS line.6. Don t forget to short two relay wires (EWS connector)!7. Car is ready to start.Colour:greenMaterial:Electronic componentPackage Contents:1 x Emulator(without wire)Only the above package content, other products are not included.Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.