Item Type: Temperature Controller_x000D_ Material: ABS_x000D_ Temperature Measuring Probe: NTC10K_x000D_ Sensor Wire Length: Approx. 2m / 6.6ft_x000D_ Temperature Measurement Range: -50~110_x000D_ Temperature Measurement Accuracy: 0.1_x000D_ Output Current: 10A_x000D_ Support Power: 2000W_x000D_ Size: Approx. 147 x 96 x 45mm / 5.8 x 3.8 x 1.8in_x000D_ Uses: Widely used in the field of incubation, equipment chassis, air conditioning systems, temperature control protection and other fields_x000D_ How to Use: _x000D_ 1. Set the Temperature Calibration: If The Real-time Measured Temperature Is Different From The Actual temperature, press this key to adjust; method: Long press the calibration key to display ADJ and flashing words, press the up and down keys to adjust, then press the enter key to save and exit_x000D_ 2. Set the Stop and Start Temperature: Press the set button once, the stop temperature flashes, press the up and down keys to adjust; press the set button again, the start temperature flashes, press the up and down keys to adjust, press the enter key to save_x000D_ 3. Restore Factory Settings: After power-on, press the up and down keys at the same time for more than 3 seconds, after displaying 888, the recovery is successful; when LLL is displayed, it means that the temperature sensor is not plugged in, disconnected, or damaged, just replace it; when HHH is displayed, it means it exceeds 110 measuring range, or the sensor is short-circuited, the sensor needs to be replaced