Notice: The microphone is very sensitive; avoid dropping, knocking, or exposing it to strong shocks. If the microphone is placed near a speaker, feedback may occur—position the microphone away from the speaker or reduce the speaker volume to prevent this. Switching between pickup modes may produce noise. The battery indicator on the microphone lights up briefly when powered on and then turns off automatically to conserve battery power and prevent interference with video recording. Always check the switch to confirm it is properly activated, and turn the microphone off when not in use. When the battery indicator flashes once upon turning on, or if the power light illuminates during use, this indicates low battery. The microphone can still operate for one to two hours under these conditions, but replace the battery promptly. Product Name: Microphone For Camera Model: MIC-01 Cable Length: Approximately 20 cm Frequency Response: 30–15,000 Hz Sensitivity: -40 dB (0 dB = 1 V/Pa at 1 kHz) Directional Characteristics: Single Directional x 2 Output Impedance: 200 Ohm Signal-to-Noise Ratio: 76 dB (1 kHz at 1 Pa) Maximum Sound Pressure Level: 120 dB at 1 kHz (harmonic distortion of 1% or less) Power Supply: 3V DC Connector Type: MS (Mid-Side) Stereo Wire Power Requirement: 3V CR2 battery Battery Life: Approximately 800 hours (at room temperature, using included 3V CR2 lithium battery) Compatibility: Compatible with any D-SLR camera equipped with a 3.5mm microphone input and standard hot shoe How To Use: 1. Slide the adapter onto the camera’s hot shoe to securely mount the microphone. 2. Ensure the camera is powered off before connecting the microphone’s L-shaped mini stereo plug to the camera’s microphone input port. Dimensions: 132 x 30.5 x 61 mm Material: ABS Color: Black Package Contents: 1 x Microphone (camera not included) 1 x Battery 1 x User Manual Note: Colors may vary slightly due to lighting and display settings. Measurement tolerance: ±1–3 cm.