M10Q-5883 GPS Compass Module for RC FPV Drone Flight Controller

Product Details 1. Multi-constellation GNSS System: Equipped with SAM-M10Q-00B module, supports GPS, GLONASS, Galileo, and BeiDou. Enables enhanced position availability in complex environments (e.g., urban canyons) via multi-system signal reception. 2. High-Sensitivity GNSS: Super-S signal technology ensures excellent RF sensitivity and fast 3D fix acquisition, even in non-line-of-sight scenarios. 3. Optimal Antenna Design: 15x15mm2 high-gain patch antenna balances performance and compact size, with omnidirectional pattern for flexible installation. 4. Wide Voltage Compatibility: Operates on 4~9V input range (5V pad/pin), suitable for various RC FPV racing drones with different battery setups. 5. Low Power Consumption: 13mA power draw minimizes energy usage, extending flight time for lightweight drones. 6. Dual Interfaces: UART (TX/RX) for GNSS and I2C (DA/CL) for compass, compatible with popular flight controllers (Betaflight, ArduPilot, INAV). 7. Clear Status LED: Green PPS LED indicates status—solid ON (powered), 1Hz blink (3D fix achieved), simplifying setup and debugging. 8. Compact & Lightweight: 20x20x12.4mm dimensions and 8g weight fit tight drone frames without bulk. Specifications 1. GNSS Module: SAM-M10Q-00B (GPS, GLONASS, Galileo, BeiDou) 2. Compass Module: QMC5883L 3. Antenna: 15x15x4mm high-gain patch antenna 4. Input Voltage: 4~9V (5V pad/pin) 5. Power Consumption: 13mA 6. UART Baudrate: 9600 (default) 7. Protocol: UBX (5Hz@GPS+GAL+BDS B1C+GLO) or NMEA (1Hz) 8. Operating Temperature: -20°C ~ 80°C 9. Dimensions: 20mm x 20mm x 12.4mm 10. Weight: 8g 11. Connector: JST-GH-6P (1.27mm pitch) 12. Interfaces: UART (TX, RX) for GNSS; I2C (DA, CL) for compass Packing List 1. 1 x Matek M10Q-5883 GNSS GPS & Compa Module 2. 1 x JST-GH-6P to JST-GH-6P 20cm silicon wire Warm Tips 1. Compass Alignment: Flat mounting only; tilting the magnetometer is strongly discouraged. 2. Flight Controller Settings: - INAV/Betaflight (compa arrow forward): Set CW 270° flip; (compa arrow backward): Set CW 90° flip. - ArduPilot/Mission Planner: No rotation adjustment required. 3. Interference Avoidance: Keep compass 10cm+ away from power lines, ESCs, motors, or iron-based materials. 4. Firmware Requirement: INAV 5.0.0+, Betaflight 4.3.0+, or ArduPilot 4.3+ required. 5. Reset Function: No built-in dataflash; reset by bridging RST pad to GND for 100ms (cold start). 6. LED Indication: Green PPS LED is solid ON (powered); blinks at 1Hz (3D fix achieved). 7. Antenna Care: Ceramic surface scratches are normal (tuning marks); do not damage the antenna.